D i s a s s e m b l i n g a n d R e a s s e m b l i n g o f t h e P r i m a r y
Reduction Gear Case
1. Make sure the key-switch is in the "OFF" position, then remove
the key.
2. Place the forward-reverse switch in the center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to prevent vehicle
movement.
5. Disconnect the main positive and negative cables at the
batteries.
6. Raise the rear of the vehicle and support with jack stands.
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle. Failure
to use lifting and support devices of rated load capacity
may result in serious bodily injury.
7. Drain the oil from the front gear case into an
appropriate receptacle.
8. If constrained by space remove the drive
assembly from the vehicle. Use the appropriate
proceedure to remove the motor, hydraulic
brake assemblies, and park brake cables.
SECTION 3
PAGE 39
MB-T48-01
Drain Plug