Set New Recipe (No Smart Funnel , G9-2T Dbc Or Mhg Grinder) - Bunn DUAL SH DBC Operating Manual

PROGRAMMING FUNCTIONS (cont.)
SET NEW RECIPE
If not using a Smart Funnel
and/or a G9-2T DBC or MHG Grinder, the brewer will
function as a standard Bunn
It is possible to operate the brewer without using
a Smart Funnel ® and/or a G9-2T DBC or MHG Grinder.
If a standard funnel, or if a non-DBC grinder is used
the brewer will automatically select a NO NAME coffee
fl avor when the pad is pressed. This means that
no name was read from the funnel's handle.
There are two NO NAME coffee programs that can
be set in the brewer. They are referred to as NO NAME
LEFT and NO NAME RIGHT. The left and right sides of
the brewer can be set up independently of each other.
This includes BREW VOLUMES, BYPASS PERCENT-
AGES, PULSE BREW TIMES, PREINFUSION TIMES
and DRIP-OUT TIMES. The brewer will perform in the
same capacity as a standard Bunn
The instructions for programming the NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to MODIFY A RECIPE, beginning on page 22.
Note that when the display reads NO NAME LEFT,
that is when MODIFY should be pressed in order to
set the parameters for the NO NAME LEFT coffee.
Otherwise, press NEXT to display NO NAME
RIGHT.
At this point, MODIFY should be pressed in order to
set the parameters for the NO NAME RIGHT coffee.
NOTE: Before beginning setup, insert a funnel into the
left and right side funnel rails, and place a Soft Heat
Server beneath each brew funnel.
® (with a sensor coil)
® ®
Dual Brewer:
® Dual ® Brewer.
®
Page 21
REVIEW RECIPES?
NO
EXIT TO
NEXT FUNCTION
SCREEN
NO-NAME LEFT
MODIFYSHOWNEXT
BREW OZ. XX.X
(-) DONE (+)
YES
NO-NAME RIGHT
MODIFYSHOWNEXT
BREW OZ. XX.X
(-) DONE (+)
P2419
29877.2 121504