Set New Recipe (No Smart Funnel ® Or G92T Dbc Or Mhg Grinder) - Bunn Single SH BrewWISE DBC Installation And Operating Manual

PROGRAMMING THE BREWER (cont.)
SET NEW RECIPE:
If not using a Smart Funnel (with a computer chip)
and/or a G92T DBC Grinder, the brewer will function
as a standard BUNN Single Brewer:
It is possible to operate the brewer without using
a Smart Funnel and/or a G92T DBC or MHG Grinder.
If a standard funnel, or if a non-DBC grinder is used
the brewer will automatically select a NO NAME coffee
name when the switch is pressed. This means that no
name was read from the funnel's handle.
There is a NO NAME coffee program that can be set
in the brewer. This includes BREW VOLUMES, BYPASS
PERCENTAGES, PULSE BREW TIMES and DRIP-OUT
TIMES. The brewer will perform in the same capacity
as a standard BUNN Single Brewer.
The instructions for programming the NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to MODIFY A RECIPE, beginning on page 20.
Note that when the display reads NO NAME, that
is when MODIFY should be pressed in order to set the
parameters for the NO NAME coffee.
NOTE: Before beginning setup, insert a funnel into
the funnel rails, and place a Soft Heat Server beneath
the brew funnel.
REVIEW RECIPES?
NO
EXIT TO
NEXT FUNCTION
SCREEN
MODIFYSHOWNEXT
BREW OZ. XX.X
(-) DONE
Page 20
YES
NO-NAME
(COFFEE NAME)
MODIFYSHOWNEXT
(+)
BREW OZ. XX.X
(-) DONE (+)
P2441
34025.2 071105