Brew Counters (View/Reset); Funnel Detect - Bunn DUAL SH DBC Operating Manual

PROGRAMMING FUNCTIONS - (cont.)
BREW COUNTERS
This function allows the operator to track the
number of brew cycles completed on the left side, the
right side, and the total of both combined. There are
three resettable counters, and one life counter that is
not resettable.
BREW COUNTERS?
NO
EXIT TO
NEXT FUNCTION
SCREEN
LEFT
NEXT RESET
RIGHT
NEXT RESET
L + R
NEXT RESET
L + R
NEXT
Procedures to view/reset the brew counters:
1. Press and hold upper right hidden switch until the
display reads SET NEW RECIPES. Release switch.
Press and release upper right hidden switch until
the display reads BREW COUNTERS.
2. Pressing NO in this screen will advance to the
next function. Press YES to view the fi rst brew
counter (left). This number represents the brew
cycles initiated since that counter was last reset.
3. To advance to the other counters, press and release
NEXT. The four counters are as follows:
LEFT - total brews on the left side (resettable)
RIGHT - total brews on the right side (reset-
table)
LEFT AND RIGHT - total brews on the left and right
sides combined (resettable)
LEFT AND RIGHT - total brews on the left and right
sides combined (non-resettable)
4. To reset any of the counters to zero (except for the
non-resettable counter), press and release RESET
YES
XXXX
RESETS LEFT
COUNTER
XXXX
RESETS RIGHT
COUNTER
XXXX
RESETS BOTH
LEFT AND RIGHT
COUNTERS
XXXX
P2308
when viewing that particular counter's screen.
5. When fi nished, press NEXT to advance counter
screens until the display reads BREW COUN-
TERS. Press and release NO to advance to the
next function screen, or press and release either
of the pads on the front switch panel to exit
the BREW COUNTERS function and return to the
MAIN SCREEN.
FUNNEL DETECT (optional)
This function allows the operator to prevent the
start of a brew cycle if a Smart Funnel is not positioned
correctly in the funnel rails.

FUNNEL DETECT?

NO
Procedure to set funnel detect:
1. Press and hold upper right hidden switch until the
display reads SET NEW RECIPES. Release switch.
Press and release upper right hidden switch until
the display reads FUNNEL DETECT.
2. NO or YES should be fl ashing to indicate the cur-
rent setting.
4. Select YES to prevent brewing if a Smart Funnel is
not correctly situated in the rails. If this function
is activated and a brew cycle is attempted with the
funnel not properly situated, the display will read,
FUNNEL NOT IN PLACE, until one is in place.
5. Select NO to allow brewing without a Smart Fun-
nel in place. This is selected when brewing with a
funnel other than a Smart Funnel (a regular brew
funnel).
6. When fi nished, press and release DONE. This will
retain the changes, exit this function screen and
advance to the next. Another alternative is to press
either of the
panel to exit the FUNNEL DETECT and return to
the MAIN SCREEN.
Page 36
DONE YES
pads located on the front switch
29877.2 121504
P2309