Set Drip Times - Bunn DUAL SH DBC Operating Manual

PROGRAMMING FUNCTIONS (cont.)
SET NEW RECIPES (cont.)
15. If the three batch sizes are not correct, press and
release NO to return to the % BYPASS setup screen
and repeat steps 12 through 15. If they are cor-
rect, press YES. This will advance to SET PULSE
BREW. (Refer to page 25 for description of SET
PULSE BREW function.
16. To SET PULSE BREW, if setting pulse brew BY
EXAMPLE (brewing into a funnel) press YES and
proceed with the setup instructions for SETTING
PULSE BREW - BY EXAMPLE, on page 27.
17. If setting pulse brew by ENTER TIMES (entering
known times) press NO. The display should read
ENTER TIMES. Press and release YES and proceed
with the setup instructions for SETTING PULSE
BREW - ENTER TIMES, page 28. After SET PULSE
BREW has been accomplished, the next function
will be SET PREINFUSION. (Refer to page 29 for
description of SET PREINFUSION function.
DRIP TIME X:XX
(-) DONE
3 BATCHES DONE?
NO
(COFFEE NAME)
SETUP COMPLETE
18. To SET PREINFUSION press YES in the SET PRE-
INFUSION screen to proceed. The display should
now read ON TIME and a batch light will be blink-
ing.
19. Using (-) and (+), set the amount of time the brew
water will initially presoak the grounds for that
particular batch size.
20. When fi nished, press another batch size and repeat
until all three batch sizes are set.
21. When fi nished, press DONE. The display should
now read OFF TIME and a batch light will be blink-
(+)
YES
P2418
Page 19
ing.
22. Using (-) and (+), set the amount of time the brew
cycle will delay (after the presoak cycle shuts off)
before resuming brewing.
23. When fi nished, press another batch size and repeat
until all three batch sizes are set.
24. When fi nished setting all batch sizes, press DONE.
The display will show the ON and OFF TIMES that
were entered for a particular batch size. After a 5
second delay, the display should read 3 BATCHES
DONE.
25. If the three batches are not complete, press NO in
order to return to SET PREINFUSION, and repeat
steps 19 through 24.
26. If the three batches are correct, press YES. This
will advance to the next function, SET DRIP TIME.
(Refer to page 30 for description of SET DRIP
TIME function.)
27. The display should now read DRIP TIME, along
with either the word OFF, or a time will be showing.
A batch light should also be blinking.
28. Using (-) and (+), set the amount of time from
when the brew spray ends to when the funnel is
emptied of hot liquid for that batch size.
NOTE: Set to OFF to prevent funnel locks from engaging
(to disable this function), for a particular batch size.
To set to OFF, continue to press and release (-) until
OFF appears on the screen.
29. When fi nished, press another batch size and repeat
step 28 until all three sizes are set.
30. When fi nished setting all batch sizes press DONE.
The display should read 3 BATCHES DONE?.
31. If the three batch sizes are not correct, press NO to
return to the DRIP TIME setup screen and repeat
steps 28 through 30.
32. If the three batch sizes are correct, press YES.
The screen should show the name of the coffee
being programmed (modifi ed) along with SETUP
COMPLETE.
32. After a 5 second delay, the display will advance to
the next coffee name in the brewer's memory. If
no other coffee names are present, the display will
read THAT WAS THE LAST RECIPE, and return to
the REVIEW RECIPES screen.
29877.2 121504