Server Detect; Service Tools; Test Frequency - Bunn DUAL SH DBC Operating Manual

PROGRAMMING FUNCTIONS - (cont.)

SERVER DETECT

This function allows the operator to prevent the start
of a brew cycle if a Soft Heat
correctly on the brewer.
SERVER DETECT ?
NO DONE
Procedures to set server detect:
1. Press and hold the upper right hidden switch until
the display reads SET NEW RECIPE. Release the
switch. Press and release the upper right hidden
switch until the display reads SERVER DETECT.
2. The NO or YES fl ashes to indicate the current
selection.
3. Select YES to prevent brewing if the Soft Heat
server is not correctly positioned on the brewer
beneath the funnel.
NOTE: If YES is selected and a brew cycle is attempted
with a server not properly placed, the display will read
SERVER NOT IN PLACE.
4. Select NO to allow brewing without a Soft Heat
server in place. This is selected when brewing into
a container other than a Soft Heat
5. When fi nished, press and release DONE. This will
save the new setting, exit the function screen and
advance to SERVICE TOOLS. Another alternative
is to press either of the
front switch panel to exit the SERVER DETECT
function and return to the MAIN SCREEN.
® server is not positioned
YES
P2310
® Server.
pads located on the

SERVICE TOOLS

This function allows the testing of individual com-
ponents and the ability to check switches for proper
function. This function also tests the Soft Heat server's
status on the brewer (in place or removed), and the
funnel sensor coil's frequency (diagnostic tool for
troubleshooting purposes only).
EXIT TO
NEXT FUNCTION
SCREEN
TEST SWITCHES?
NO
®
NOTHING PRESSED
TEST SERVERS?
NO
®

TEST FREQUENCY?

NO
EXIT TO
NEXT FUNCTION
SCREEN
Page 37
SERVICE TOOLS?
NO YES
TEST OUTPUTS?
NO YES
PRESS AND RELEASE
® SYMBOL
YES
LEFT BREW VALVE
ON
SERVER REMOVED
YES
IN PLACE
PRESS AND RELEASE
® SYMBOL
YES
125.0 KHZ.
4 125.0 KHZ.
PRESS AND RELEASE
® SYMBOL
NEXT OFF
NEXT COMPONENT
TO BE TESTED
4
P2311
29877.2 121504