Program Functions (Level 2); Units (Setting Units Of Measure) - Bunn DUAL SH DBC Operating Manual

PROGRAMMING FUNCTIONS - (cont.)

UNITS (SETTING UNITS OF MEASURE)

This function allows the units of measure to be
set in English or Metric readings for all screens. The
program is defaulted to English.
WARNING: Changing the unit of measure will erase all
coffee recipes stored in memory. All preinfusion,
pulse times, etc will also be erased. If using this
option after information has been stored, it is im-
portant to have this information stored elsewhere
so that the machine can be reprogrammed.
Procedure for modifying units of measure:
1. Press and hold upper right hidden switch until the
display reads UNITS. Release switch. Press and
release METRIC or ENG to make a selection.
2. Press DONE to proceed. The display should now
read CHANGING UNITS!! WILL ERASE!! ... ALL
PREVIOUSLY STORED RECIPES AND ALL SETUP
INFO WILL BE LOST ... ARE YOU SURE?.
3. Press YES to begin the change. While the change
is in process, the display will read RESTORING
DEFAULTS and a count down will begin.
4. When the count down reaches 0 the display will read
SET NEW RECIPE? The units have been reset.
5. Press and release either of the
on the front switch panel to exit the UNITS function
and return to the MAIN SCREEN.
PROGRAM FUNCTIONS - LEVEL 2
SELECTS METRIC
UNIT OF MEASURE
pads located
Page 16
UNITS
METRIC DONE ENG
CHANGING UNITS
AS THE
WILL!! ERASE!!
ALL PREVIOUSLY
STORED RECIPES
AND ALL SETUP
INFO WIL BE LOST!
ARE YOU SURE?
YES
REPLACE
SELECTS ENGLISH
AS THE
UNIT OF MEASURE
NO
EXIT
P3259.70
29877.2 121504