Set New Recipe (Using A Recipe Card) - Bunn DUAL SH DBC Operating Manual

PROGRAMMING FUNCTIONS (cont.)
SET NEW RECIPE
Using a RECIPE CARD to load coffee names and
brew settings into the Dual
Funnel ® :
The G9-2T DBC or MHG's memory contains cer-
tain coffee names. If the operator uses a coffee name
that is not already stored in the grinder's memory,
a RECIPE CARD can be obtained from the factory.
The RECIPE CARD would include all the information
needed to set up that particular coffee name. The in-
formation from the RECIPE CARD is loaded into the
grinder's memory, then into the brewer's memory by
holding the chip area up to the equipment's sensing
coil. This information can include the coffee name,
BREW VOLUMES, BYPASS PERCENTAGES, PULSE
BREW TIMES, PREINFUSION TIMES and DRIP-OUT
TIMES for that particular coffee NAME. These can all
be loaded in seconds.
Contact Bunn-O-Matic Corporation for the avail-
ability of RECIPE CARDS.
NOTE: Instructions to program the brewer and grinder
are printed on the RECIPE CARD, along with the coffee
name that is being programmed.
Procedure to program the coffee name:
1. Remove the funnels (if present) from the left and
right funnel rails.
2. Position the RECIPE CARD vertically, so that the
top end of the chip is beneath the left side funnel
sensing coil.
3. After a short pause the display will read CARD CON-
TAINS RECIPE FOR then will change to (COFFEE
NAME) SHOW QUIT SAVE. All brewing parameters
for that coffee fl avor are now transferred from the
CARD to the brewer.
4. To show (view) this information, press and release
SHOW. The display will scroll through all of the
brew settings for all three batch sizes. The display
will then return to CARD CONTAINS RECIPE FOR
then will change to (COFFEE NAME) SHOW QUIT
SAVE.
5. If all brew settings are correct, press SAVE. The
display will read (COFFEE NAME) SETUP COM-
PLETE. All brew settings for that name are now
®
SH DBC with Smart
Page 20
stored in the brewer's memory.
6. If the brewing information is not correct, or it is
desired to exit the setup before the settings are
loaded into the brewer's memory, press QUIT. The
display will read (COFFEE NAME) NOT SAVED. The
READY TO BREW
WATER TEMP: 200º
POSITION CARD UNDER THE
LEFT SIDE SENSOR COIL
CARD CONTAINS
RECIPE FOR
(COFFEE NAME)
SHOW QUIT SAVE
SCROLLS THROUGH ALL
OF THE BREW SETTINGS
FOR THE THREE BATCH
SIZES FOR THAT COFFEE
FLAVOR
(COFFEE NAME)
NOT SAVED
(COFFEE NAME)
SETUP COMPLETE
P2300
29877.2 121504