Booting The Server - HP Integrity rx4640 Operation And Maintenance Manual

Booting the Server

To boot the server, perform the following step.
1. Depress the power switch located to the left of the front panel LEDs.
NOTE
If the front bezel is attached and in the closed position, you will need to open the small door on the front bezel
to gain access to the power switch.
If the autoboot function is enabled, the system will boot to the installed operating system. If autoboot is not enabled, the
system will enter the EFI boot manager. The EFI boot manager allows you to control the server's booting environment. For
more information about the EFI boot manager, review Chapter 5, "Utilities."
Chapter 4
Installing Additional Components and Configuring
Booting the Server
85