Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety
precautions could result in damage to the server.
Figure 7-37
QuickFind Diagnostic Board Removal and Replacement
Removing the QuickFind Diagnostic Board
To remove the QuickFind diagnostic board, perform the following steps:
Step
1. If rack mounted, slide the HP Server out from the rack until it stops. See "Accessing a Rack Mounted Server" on
page 141.
Step
2. Remove the top cover. See "Front and Top Covers" on page 145.
Chapter 7
Removing and Replacing Components
QuickFind Diagnostic Board
Cover
QuickFind
diagnostic board
219