Configuring Management Processor Lan Information; Figure 4-22The Mp Main Menu - HP Integrity rx4640 Operation And Maintenance Manual

Installing Additional Components and Configuring
Core I/O Connections
Step 3. Log out using the X command (enter X at the MP> prompt) after returning to the MP Main Menu.

Figure 4-22The MP Main Menu

MP MAIN MENU:
VFP: Virtual Front Panel
CSP: Connect to Service Processor

Configuring Management Processor LAN Information

LAN information includes the management processor network name, the management processor IP address, the management
processor subnet mask, the management processor gateway address, and the web console port number.
To set the management processor LAN IP address:
Step 1. At the MP Main Menu prompt (MP>), enter CM to select command mode.
Step 2. At the command mode prompt (MP:CM>), enter LC (for LAN configuration).
The screen displays the default values and asks if you want to modify them. It is good practice to write down the
information, as it may be required for future troubleshooting. See "The LC Command Screen".
NOTE
Step 3. The current lc data is displayed. When prompted to enter a parameter name, A to modify All, or Q to Quit,
enter A to select all parameters.
Step 4. The current IP address is displayed. When prompted to enter a new value or Q, enter the new IP address.
Step 5. The current host name is displayed. When prompted to enter a new value or Q, enter the new management
processor network name.
This is the host name for the management processor LAN, The name can be up to 64 characters in length, and can
include dashes, underlines, periods, and spaces.
Step 6. The current subnet mask name is displayed. When prompted to enter a new value or Q, enter the new subnet mask
name.
Step 7. The current gateway address is displayed. When prompted to enter a new value or Q, enter the new gateway
address.
Step 8. The current web console port number is displayed. When prompted to enter a new value or Q, just hit
message -> Current Web Console Port Number has been retained will be displayed.
Step 9. The current link state information is displayed. When prompted to enter a new value or Q, just press
message -> Current Link State has been retained will be displayed.
74
CO: Console
CM: Command Menu
CL: Console Logs
SL: Show Event Logs
SE: Create OS Session
HE: Main Menu Help
X: Exit Connection
The value in the "IP address" field is set at the factory. The customer must provide the actual
management processor LAN IP address.
. The
enter
. The
enter
Chapter 4