HP Integrity rx4640 Operation And Maintenance Manual page 107

Step 7. You may display (and optionally change) any SCSI parameters listed below for this channel of this SCSI board, or
restore its SCSI parameters to their default values.
• SCSI ID
• Maximum data transfer rate
• Bus width
• Whether the HBA is bootable (driver support)
• Avoid bus resets (secondary cluster server)
• Restore Defaults
Step 8. Use the arrow keys to navigate to the appropriate SCSI parameter.
Step 9. Use the plus ( +
Step 10. Press to exit the "Adapter Properties" screen. You are given these choices:
Esc
• Cancel the exit from the screen (to stay in the "Adapter Properties" screen for this channel of this SCSI board)
• Save the changes you made and then exit the screen
• Discard the changes you made and then exit the screen
Step 11. Move the cursor to the action (cancel, save, or discard) you want to take; press
If you selected cancel, you remain in the "Adapter Properties" screen for this channel of this SCSI board. You can
still change this channel's parameters listed above.
If you selected save or discard, you are placed in the EFI SCSI Setup Utility's main menu.
CAUTION
Step 12. Press to exit the main menu and the EFI SCSI Setup Utility.
Esc
Step 13. Select the option for exiting the utility.
Step 14. When you are prompted to, press
Step 15. At the EFI shell prompt, type this command:
reset
The system starts to reboot. This is required to cause the new SCSI setting.
Chapter 5
•
Format
•
Verify
Changing any of these fields can cause unpredictable results.
) and minus ( - ) keys to scroll through the values until the value you want is displayed.
Do not select the <Global Properties> option on the main menu.
to stop this SCSI board; you are now back at the EFI shell prompt.
Enter
Specifying SCSI Parameters
.
Enter
Utilities
107