Table of Contents
Advertisement
USERS IN CANADA
PRE-INSTALLATION REQUIREMENTS FOR CANON
FACSIMILE EQUIPMENT
A. Location
Supply a suitable table, cabinet, or desk. See Appendix for the unit's
dimensions and weight.
B. Order Information
1.
2.
3.
n
Canon recommends an individual line following industry standards
[e.g., the 2500 (Touch Tone) or 500 (Rotary/Pulse Dial) telephones]. A
dedicated extension of a PBX unit without "Camp On" signals is also
permissible with a fax unit. Key telephone systems are not recommended
because they send non-standard signals to individual telephones for
ringing and special codes, which may cause a fax error.
C. Power Requirements
The power outlet should be a three-prong grounded receptacle
(Single or Duplex). It should be independent from copiers, heaters,
air conditioners, or any electric equipment that is thermostatically
controlled. The rated value is 120 volts and 15 amperes. The CA11A
modular jack should be relatively close to the power outlet to
facilitate installation.
viii
Provide only a single-line to touch-tone or rotary telephone set
terminated with a standard 4-pin modular phone plug.
(Touch-tone is recommended if available in your area.)
Order an CA11A modular jack (USOC code), which should be
installed by the phone company. If the CA11A jack is not present,
installation cannot occur.
Order a normal business line from your telephone company's
business representative. The line should be a regular voice grade
line or equivalent. Use one line per unit.
DDD (DIRECT DISTANCE DIAL) LINE
or
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IF
YOU COMMUNICATE OVERSEAS
Preface
Advertisement
Table of Contents
