Table of Contents
Advertisement
22. Press Set again, then use N N N N or M M M M to select RECEIVE or
DISCONNECT.
23. Press Set.
24. Press Stop to return to standby mode.
N
When DRPD is selected, the communication type for each ring pattern
defaults to TEL (except for the DOUBLE RING pattern which defaults to
FAX/TEL AUTO SW). After you select the ring pattern that has been
assigned for your fax communications, you need to make sure that the
other ring patterns are not set to FAX. Otherwise, the LASER CLASS 2060
may answer as a fax for each ring pattern.
7-20
Receiving Faxes
Set
This setting tells the unit what to do if no one picks up the
handset within the specified ring time set in step 20.
Select RECEIVE to receive the call, and DISCONNECT to
disconnect the call.
Set
Stop
F / T S W I T C H A C T I O N
R E C E I V E
F / T S W I T C H A C T I O N
D I S C O N N E C T
R X S E T T I N G S
3 . I N C O M I N G R I N G
1 2 / 3 1 / 1 9 9 9 F R I 1 0 : 0 0
D R P D
S T A N D A R D
Chapter 7
Advertisement
Table of Contents
