Table of Contents
Advertisement
Removing Shipping Materials
In order to protect your LASER CLASS 2060 during shipping, the unit has
been packed with protective material that you must remove before using.
Follow these steps:
1.
Remove all pieces of shipping tape from the outside of the LASER
CLASS 2060.
2.
Open the operation panel by grasping it with both hands and gently
pulling it toward you.
Remove the soft styrene foam sheet from the Automatic Document
Feeder (ADF), then gently close the operation panel by pressing it
down from the center until it clicks.
2-10
Setting Up Your LASER CLASS 2060
Chapter 2
Advertisement
Table of Contents
