20° Tilt Module With Flex 2 Seat - Invacare Kite Service Manual

SERVICE MANUAL
10.1.2 20° tilt module with Flex 2 seat
Requirements:
· 5 mm Allen wrench
· Screwdriver, flat, width approx. 6 mm
· Small hammer
WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
· Let a second person help you.
Overview of the fixation points, depending on desired seat height:
Seat
height
in cm
46
48
50
Adjusting the actuator holder on the chassis
Detailed instructions on the actuator can be
found in chapter 8.15.
·
Use the screwdriver to remove the SL-
retainer of the lower holding bolt.
·
Place a support under the seat.
·
Pull the holding bolt.
·
Adjust the actuator with holding bolt to the
desired height, according to the above table.
·
Secure the holding bolt with the SL-retainer.
·
Place a support under the seat.
·
Use the Allen wrench to loosen the screw (1)
and remove. Pay attention to the washer
while doing so.
·
Adjust the seat with the screw (1) to the
desired height, according to the above table.
·
Tighten the screw (1).
110
20° tilt with Flex 2 seat
B C
X
X
Actuator holder
D b
X
X
®
Invacare - Kite
c d
X
X