Replacing The Tilt Actuator - Invacare Kite Service Manual

SERVICE MANUAL
8.15

Replacing the tilt actuator

Requirements:
· flat screwdriver, blade width approx. 6 mm
· oblique pliers
· small hammer
· cable binder
·
Remove the legrests.
·
Switch the electronics OFF on the remote.
·
Remove the rear and the middle covers, as described in chapter 8.1.1 und 8.1.2.
·
Take exact note of the positions of all cables and the sockets that they are connected to. Mark
the connectors and sockets or take a photograph with a digital camera.
·
Disconnect the plug (1) of the actuator to be tested from the actuator module.
·
Pull the actuator cable out of the wheelchair. If necessary, also remove the cable ties.
·
Remove the SL fuse (2) on the bottom fixing
bolt (1) with the screwdriver.
·
Pull the fixing bolt (1) out.
86
®
Invacare - Kite