Luggage Carrier - Invacare Kite Service Manual

®
Invacare - Kite
9.4

Luggage carrier

Requirements:
· 5 mm Allen wrench
· 10 mm open-ended wrench
·
If no conventional lighting system is installed:
Loosen and remove both hexagon socket head screws (4) together with the washer.
·
If a conventional lighting system is present:
Loosen and remove both of the hexagon socket head screws (4) including the washers,
spacer sleeve, etc. Also see chapter 8.7.9.
·
Install the luggage carrier fixation bracket (3).
·
If a conventional lighting system is present:
Install the light bracket. Also see chapter 8.7.9.
·
Install both hexagon socket head screws (4) together with the washers, spacer sleeve, etc.
·
Repeat these work steps on the other side of the wheelchair.
·
Open the clamping levers (5) of the luggage carrier fixation bracket.
·
Push the brackets onto the luggage carrier (1).
·
Install the luggage carrier with the brackets. When tightening the screws (2), make sure that
the luggage carrier is correctly centered.
SERVICE MANUAL
105