Replacing The Double Bearing Of The Dual Swing Technology (D.s.t.) - Invacare Kite Service Manual

®
Invacare - Kite
8.13 Replacing the double bearing of the Dual Swing Technology
(D.S.T.)
Requirements:
· 4 mm Allen wrench
· 5 mm Allen wrench
· 10 mm Allen wrench
· 11 mm socket wrench
· 13 mm socket wrench
· 13 mm open-ended wrench
· 24 mm open-ended wrench
· 36 mm open-ended wrench
· 24 mm box wrench
· torque wrench 20 – 200 Nm
· wooden blocks
Disassembling the double bearing of the Dual Swing Technology (D.S.T.)
·
Remove both batteries, as described in chapter 8.4.
·
Remove the middle cover, as described in chapter 8.1.2.
·
Remove both lateral covers, as described in chapter 8.1.3.
·
Remove all cables that run from the electronic modules on the battery box to the seat (for
example to the remote or actuators) or to the tube frame (for example to the lighting system).
·
Place wooden blocks under the battery box, so that it is secured in its present position.
·
Loosen the lower screws on both rubber shock absorbers, as described in chapter 8.11.
WARNING!
Risk of damage to the tube frame.
· You should counter the bearing bolt against slippage, but do not turn it.
·
Secure the bearing bolt (1) against slippage using a second 24 mm open-end wrench.
·
Use a 19 mm box wrench to loosen the nut (4).
·
Remove the bearing bolt. Pay attention to the self-locking nut (4), the washers as well as the
sliding bushing (5).
SERVICE MANUAL
83