Table of Contents
Advertisement
1.
Knob to open valve to fill or to use camper.
2.
Complete valve assembly.
3.
"10%" valve, small brass knob or slot screw.
4.
Container mounting stand.
A warning label has been located near the LP gas container. This label reads:
THIS GAS PIPING SYSTEM IS DESIGNED FOR USE OF LIQUEFIED
PETROLEUM GAS ONLY. DO NOT CONNECT NATURAL GAS
TO THIS SYSTEM. DO NOT FILL CONTAINER(S) TO MORE
THAN 80 PERCENT OF CAPACITY. Securely cap inlet(s) when
not connected for use. After
normal container replacement, test gas piping and connections
to appliances for leakage with soapy water or bubble solution.
Do not use products that contain ammonia or chlorine.
AD-34
Main Supply Hose – Low Pressure
The main supply hose will be attached from regulator to brass manifold fitting in frame of
coach. Swivel brass nut on main hose will be your final attachment. Several things to
remember each time container is removed:
1. Be sure ALL fittings are tight.
2. Be sure ALL connections are tested with leak solution.
3. Open main valve slowly to avoid fast rush of gas to excess flow valve causing gas
freeze up. Should you experience a gas "freeze-up," close main valve and wait 15
minutes before trying again.
4. Listen carefully - a "hissing" sound longer than one second may indicate a gas leak.
Close valve and search for leak.
ALL GAS LINES HAVE BEEN CHECKED WITH AIR
PRESSURE. DEALERS ARE REQUIRED TO RECHECK AND
ADJUST PRESSURE BEFORE DELIVERY TO CUSTOMERS.
Fig. 4-14
turning on gas, except after
3/8" MPT x 1/2" Female
Flare Swivel
37
Fig. 4-15
Advertisement
Table of Contents
