Operations (Manual Slideout - Resort Travel Trailers) - Jayco Conventional Travel Trailer Owner's Manual

Table of Contents

RETRACTING ROOM

1. Remove all objects left between the slideout and cabinetry.

2. Turn master switch on.

3. Press the "IN" button to bring room in and hold until motor stops.

4. Release button.

5. Turn master switch to the "OFF" position.

6. Install "travel bars" in proper locations as indicated on the wall.

CAUTION: IMPORTANT! Never store slideout without the travel bars installed.

This helps seal the slideout in the closed position.

Operations (Manual Slideout – Resort Travel Trailers)

EXTENDING ROOM

1. The travel trailer must be level and the stabilizer jacks in the down position.

CAUTION: Additional support jacks are not needed under the slideout. Damage

can occur to your slideout room from improper use of support jacks.

2. Remove "travel bars" from behind the top facia board located above slideout

room.

3. Unlock slideout locking mechanism.

4. Install the crank handle onto the crank shaft and turn until the room is extended. The

crank shaft is located on the opposite side of the travel trailer as the main slideout

room and is labeled, "Crank Override."

5. When the slideout is in place put pressure on the crank handle to ensure a tight seal.

This will ensure that the slideout is locked into a sealed position.

6. Engage slideout locking mechanism.

RETRACTING ROOM

1. Remove all objects from in front of the room. Check table leafs and chair positions.

2. Unlock slideout locking mechanism.

3. Install the crank handle onto the crank shaft and turn until the room is retracted. The