Jayco Conventional Travel Trailer Owner's Manual page 31

Fig. 3-4
BEDROOM SLIDEOUT OVERRIDE
Fifth-Wheel Travel Trailer Option
1. Make sure that the ON/OFF switch for the system is turned "OFF." The override
will not work if the switch is turned "ON."
2. Lift up the mattress and baseboard to gain access to the slideout unit. (Fig. 3-3)
3. From the rear of the motor, rotate the brake release lever on the back side of the
motor counter-clockwise 1/8 turn. (Fig. 3-3) This will release the brake that locks
the slideout in place.
4. Locate the quick disconnect on the red motor wire and disconnect. (Fig. 3-5 and Fig.
3-6) If the motor wire does not have a quick disconnect, locate the red wire coming
out of the motor and cut it 4 to 6 inches from the motor.
5. Use an adjustable wrench on the square end of the drive shaft and turn the shaft until
the slideout is in the position you desire. When the slideout is fully extended (or
retracted), put pressure on the crank handle to ensure a tight seal then return the
brake release lever to its normal downward position. This will ensure that the
slideout is locked into a sealed position.
6. Re-connect the motor wire. (Fig. 3-5 and Fig. 3-6)
7. Install the travel bars and take the unit to a Jayco dealer for service.
22