Operations (Electric Slideout) - Jayco Conventional Travel Trailer Owner's Manual

• A manual override system that allows you to move the room in or out in the event of
a power loss.
• A master switch to keep power from going into the module board, preventing any pos-
sible movement until you choose to move slideout.
• Ensure that the travel trailer is level before operating the slideout room.
• Ensure there are no people or obstructions blocking the path of the room when it
is moving.
• Keep away from the slide rails when the room is in motion.
• The gear assembly may pinch or catch on loose clothing causing personal injury.
• Always install travel bars for storage and transportation.
• Ensure the slideout is in the closed position prior to hooking the unit to the tow
vehicle.

Operations (Electric Slideout)

EXTENDING ROOM
1. Batteries must be fully charged and connected. The travel trailer should be hooked
up to 120-volt AC power if possible.
2. The travel trailer must be level and the stabilizer jacks in the down position.
CAUTION: Additional support jacks are not needed under the slideout. Damage
can occur to your slideout room from improper use of support jacks.
3. Remove the "travel bars" from behind the top facia board located above
slideout room.
4. Locate master switch on the slideout room control panel.
WARNING: Slideout Master Switch MUST BE in the off position unless
operating the slideout in or out. Failure to keep the slideout master switch
in the off position while not in use could result in vehicle damage or
personal injury.
5. To move room out, press the "OUT" button on switch and hold until motor stops.
Release button. Travel time – approximately twenty seconds.
6. Turn master switch "OFF."
WARNING:
Failure to follow these instructions
could result in serious injury or death.
18