Ice Maker - Jayco Conventional Travel Trailer Owner's Manual

in the center display. There is one automatic mode of operation, and three manual modes
of operation. When the mode of operation that you wish shows in the center display,
release the MODE button.
AUTOMATIC MODE OPERATION
When you select AUTO mode, the refrigerator controls automatically select the most
efficient energy source that is available for operation. If a more efficient energy source
becomes available, the refrigerator controls change from the current energy source to the
more efficient energy source.
If an energy source is available to the refrigerator, but is not operating correctly: A fault
code appears in the center display. The refrigerator controls try to change to a less
efficient energy source. If a less efficient energy source is not available, an audible alarm
sounds, and the refrigerator stops operation. Refer to the "Fault Codes" in the
manufacturer's owner's manual.
MANUAL MODE OPERATION
When you select one of the three manual modes, "AU" goes out in the center display and
either AC, LP, or DC appears. AC means that the refrigerator is operating on AC electric.
LP means that the refrigerator is operating on LP gas. DC means that the refrigerator is
operating on DC electric. If the energy source is interrupted, an audible alarm sounds, and
the refrigerator stops operation. Refer to the "Fault Codes" in the manufacturer's owner's
manual.
IGNITION OF LP GAS IN EITHER AUTO OR MANUAL MODE
NOTE: On initial startup of the refrigerator, ignition of the LP gas may not occur within
30 seconds.
If ignition of the LP gas does not occur with 30 seconds, the gas safety valve of the
refrigerator closes.
In the auto mode, the refrigerator control changes to a less efficient energy source (3-way
models only); the fault code "no" "FL" shows in the center display (2-way models only).
In the manual mode and operating on LP gas, an audible alarm starts, and the fault code
"no" "FL" shows in the center display. The audible alarm and the fault code remain until
you push the MODE button. Push the ON/OFF button two times to stop and start the
refrigerator.
If ignition does not occur after two or three times, check the LP gas supply line; consult
your local dealer or an authorized Norcold Serivice Center; change to manual mode and
operate on AC electric, or DC electric (3-way models only).

Ice Maker

Ice maker is assembled to the refrigerators at the factory as optional equipment. If the
refrigerator does not have a factory installed ice maker, one can not be added to the
refrigerator at a later time.
62