Figure 150 Port Forwarding; Table 103 Port Forwarding - ZyXEL Communications ZyWall 35 User Manual

ZyWALL 35 User's Guide

Figure 150 Port Forwarding

The following table describes the labels in this screen.

Table 103 Port Forwarding

LABEL
WAN Interface
Default Server
Go To Page
#
Active
Name
Incoming Port(s) Enter a port number here. To forward only one port, enter it again in the second field.
Port Translation
306
DESCRIPTION
Select the WAN port for which you want to view or configure address mapping rules.
In addition to the servers for specified services, NAT supports a default server. A
default server receives packets from ports that are not specified in this screen. If you
do not assign a Default Server IP address, the ZyWALL discards all packets
received for ports that are not specified here or in the remote management setup.
Choose a page from the drop-down list box to display the corresponding summary
page of the port forwarding servers.
This is the number of an individual port forwarding server entry.
Select this check box to enable the port forwarding server entry. Clear this check box
to disallow forwarding of these ports to an inside server without having to delete the
entry.
Enter a name to identify this port-forwarding rule.
To specify a range of ports, enter the last port to be forwarded in the second field.
Enter the port number here to which you want the ZyWALL to translate the incoming
port. For a range of ports, you only need to enter the first number of the range to
which you want the incoming ports translated, the ZyWALL automatically calculates
the last port of the translated port range.
Chapter 17 Network Address Translation (NAT)