ZyXEL Communications ZyWall 35 User Manual page 661

Table 30 Firewall Commands (continued)
FUNCTION
Delete
Appendix L Firewall Commands
COMMAND
config edit firewall set <set
#> rule <rule #> destaddr-
subnet <ip address> <subnet
mask>
config edit firewall set <set
#> rule <rule #> destaddr-
range <start ip address> <end
ip address>
config edit firewall set <set
#> rule <rule #> TCP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> TCP destport-
range <start port #> <end port
#>
config edit firewall set <set
#> rule <rule #> UDP destport-
single <port #>
config edit firewall set <set
#> rule <rule #> UDP destport-
range <start port #> <end port
#>
config delete firewall e-mail
config delete firewall attack
config delete firewall set
<set #>
config delete firewall set
<set #> rule<rule #>
ZyWALL 35 User's Guide
DESCRIPTION
This command sets a rule to have the
ZyWALL check for traffic with a particular
subnet destination (defined by IP address and
subnet mask).
This command sets a rule to have the
ZyWALL check for traffic going to this range of
addresses.
This command sets a rule to have the
ZyWALL check for TCP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
This command sets a rule to have the
ZyWALL check for TCP traffic with a
destination port in this range.
This command sets a rule to have the
ZyWALL check for UDP traffic with this
destination address. You may repeat this
command to enter various, non-consecutive
port numbers.
This command sets a rule to have the
ZyWALL check for UDP traffic with a
destination port in this range.
This command removes all of the settings for
e-mail alert.
This command resets all of the attack
response settings to their defaults.
This command removes the specified set from
the firewall configuration.
This command removes the specified rule in a
firewall configuration set.
659