Snmp Traps; Table 196 Snmp Traps - ZyXEL Communications ZyWall 35 User Manual

ZyWALL 35 User's Guide
Table 195 SNMP Configuration Menu Fields (continued)
FIELD
Destination
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or
[ESC] to cancel" to save your configuration or press [ESC] to cancel and go back to the previous
screen.

38.2 SNMP Traps

The ZyWALL will send traps to the SNMP manager when any one of the following events
occurs:

Table 196 SNMP Traps

TRAP # TRAP NAME
0 coldStart (defined in RFC-1215)
1 warmStart (defined in RFC-1215) A trap is sent after booting (software reboot).
4 authenticationFailure (defined in
RFC-1215)
6 whyReboot (defined in ZYXEL-
MIB)
6a For intentional reboot:
6b For fatal error:
506
DESCRIPTION
Type the IP address of the station to send your SNMP traps to.
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent to the manager when receiving any SNMP
get or set requirements with the wrong community
(password).
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warm start).
A trap is sent with the message "System reboot by
user!" if reboot is done intentionally, (for example,
download new files, CI command "sys reboot", etc.).
A trap is sent with the message of the fatal code if the
system reboots because of fatal errors.
Chapter 38 SNMP Configuration