Oce cm3521 User Manual page 544

Hide thumbs Also See for cm3521:

Table of Contents

Image Stabilization

Adjust the image density for printing on

thick paper, OHP, or envelopes. The

density can be adjusted separately for

each color (yellow, magenta, cyan and

black for a color image and the black im-

age density). The higher the setting, the

darker the density.

Adjust the setting for yellow, magenta,

cyan and black between –5 and +5.

Adjust the setting for "Black Image Den-

sity" between –2 and +2.

Perform an image stabilization if the im-

age is incorrect, even after the gradation

levels have been adjusted.

• Image Stabilization Only:

Perform normal image stabilization.

• Initialize + Image Stabilization:

Select when a good result was not

achieved after "Image Stabilization

Only" was selected.

Specify whether or not a warning appears when the left partition

glass is dirty, and specify the dirt detection level. The dirt detection

operation is performed before and after scanning an original using

Specify the level at which dirt is detected when scanning an original

using the ADF. If "Do Not Remove" is selected, the operation to re-

move lines is not performed.

Adjust the color registration if color shifts

can be seen in the print result.

Default Setting

Image Stabilization only

Troubleshooting