Using The Printer Status Monitor Program - imagistics 1630 Operating Manual

Using the Printer Status Monitor Program

Type C:\RPCX>STMX and press the Enter key to make the Printer
Status Monitor Program stay resident in your computer memory. If there
are any changes to the printer status, it displays a message on your
computer screen.
If the Printer Status Monitor program stays resident in your computer, you
can monitor the printer status on your computer screen immediately by
using the hot-key (Ctrl+Alt+R).
To remove the Printer Status Monitor program from your computer
memory, type C:\RPCX>STMX/R and press the Enter key.
The RPC works in the environment where your machine is directly
connected to your computer. If you are using printer buffer switches that
do not support bi-directional communication between the machine and
computer, the program works only in the PC to machine direction and
cannot receive Brother machine status information.
The program does not work with machines on a network.
If the RPC conflicts with some application software, exit your application
software and then run the RPC.
The RPC may work in the DOS-compatible box screen mode of
®
Windows . However, it is recommended that you completely exit from
®
Windows to the DOS prompt before using the RPC.
The Printer Status Monitor and some other Terminate-and-Stay programs
cannot coexist in the computer's memory. If they don't work properly
together, use them one at a time. You can suspend the Printer Status
monitor with any of the following methods or commands.
Type C:\RPCX>STMX/R and press the Enter key. Hold the space bar
down while executing the AUTOEXEC.BAT file at DOS startup to
prevent the status monitor from being loaded as a TSR program.
F O R D O S U S E R S 13 - 7