Table of Contents
Advertisement
Do not connect a TAM elsewhere on the same phone line.
1
Plug the telephone line cord from the wall jack into the left side of the
machine, in the jack labeled LINE.
2
Plug the telephone line cord from your TAM into the left side of the
machine, in the jack labeled EXT. (Make sure this cord is connected to the
TAM at the TAM's telephone line jack, and not its telephone set jack.)
3
Set your external TAM to four rings or less. (The machine's Ring Count
setting does not apply).
4
Record the outgoing message. (See below.)
5
Set the Answer Mode to TAM by pressing
Fax/Telephone lights are on.
Recording Outgoing Message (OGM)
Timing is important in recording this message. The message sets up the
ways to handle both manual and automatic fax reception.
1
Record 5 seconds of silence at the beginning of your message. (This
allows your machine time to listen for the fax CNG tones of automatic
transmissions before they stop.)
2
Limit your speaking to 20 seconds. (See EXT.TEL.RX, page 5-3.)
3
End your 20-second message by giving your Fax Receive Code for people
sending manual faxes. For example: "After the beep, leave a message or
send a fax by pressing
We recommend beginning your OGM with an initial 5-second silence
because the machine cannot hear fax tones over a resonant or loud voice.
You may try omitting this pause, but if your machine has trouble
receiving, then you must rerecord the OGM to include it.
2 - 10
A S S E M B L Y
5 1 and Start."
A N D
C O N N E C T I O N S
until both Fax and
Answer Mode
Advertisement
Table of Contents
