imagistics 1630 Operating Manual page 121

Difficulty
General
My headers or footers
appear when I view my will not accept print. Adjust top and bottom
Printing
document on the
Difficulties
screen but do not when
(Cont.)
when I print them.
When using ATM
fonts, some characters Settings' from the 'Start' menu. Open properties.
are missing or some
characters are printed
in the same place.
Cannot perform '2 in
1' printing.
Cannot print when
using Adobe
Illustrator.
I cannot print from my Make sure the Windows
®
Windows
application software.
Setup
Printing
Difficulties
I cannot print from my Check that the DOS application software
DOS Setup
application software.
Printing
Difficulties
The machine prints,
but it prints incorrect
information.
Sometimes
it prints a couple of
characters and then
ejects the pages, etc.
The machine prints the This is common problem first with database
part of my document
but does not print the
last page (The LCD
shows REMAINED
DATA).
T R O U B L E S H O O T I N G A N D R O U T I N E M A I N T E N A N C E
Suggestions
Most laser printers have a restricted area that
margins in your document to allow for this.
If you are using Windows 95/98, select 'Printer
Click 'Spool Setting' on the 'Details' tab.
Select 'RAW' from 'Spool Data Format'.
Check that the paper size setting in the
application and in the printer driver are the
same.
Try to reduce the printing resolution.
installed and you select it in your application
software.
interface settings match those of your printer:
for example, if you are using a parallel printer
cable, you would probably set your DOS
software printer port to LPT1. Check for an
error message on the LCD.
This is an indication that your application
printer emulation Print setting and the
machine's printer emulation do not match.
Check your application software to make sure
you selected the correct printer driver. The
machine emulates HP LaserJet IIP. Select the
HP LaserJet IIP printer in your application
software.
software and part of spreadsheet software when
they are not correctly set up. The data has been
sent to the printer but the printer did not receive
the Page Eject command. Print another
document. Then ask your software supplier how
to add a Page Eject (or Form Feed) command to
the end of your print job.
®
printer driver is
17 - 9