Tv_Out Function Introduction - Swann Max-IP-Cam Manual

2.3 TV_OUT FUNCTION INTRODUCTION

Using the following method, you can display the images from the Max-IP-Cam on your TV
The Default Video signal setting for TV_OUT is NTSC system, please press and hold
the Reset switch for 3 seconds to change to PAL system.
1. Connect the AV cable between TV set and IP Cam as shown in the illustration above.
2. Press and hold the RESET switch and plug in power adaptor at same time, continue to hold
the RESET switch for another 2 seconds then release, the IP Cam will enter into "TV Out
mode";
3. TV_OUT Operation:
- Cancel-Flicker (Ch-Flk): Press the Reset switch once, and you will see the current mode
on your screen. You can adjust Ch-Flk to select between 60Hz for USA, and Canada,
50Hz for Australia and Europe, or Outdoor for when you are observing a naturally lit
outside area;
- Hold to Exit: Press and hold down the RESET switch for 2 seconds to Exit Ch-Flk window.
6
Reset Switch