Network Setup - Swann Max-IP-Cam Manual

5.3.1 Event
Event settings, including:
- Motion Detection (set 1)
Individual or both set signal input triggers can be selected.
How to Use Event Settings:
Step 1. Activate Event for either set (MD) will automatically display the trigger sensitivity)
Step 2. After you are finished, click on Submit, otherwise;
Step 3. Click on Default to use factory default settings (sets all to off).
Note: After engaging either type of event, "Save in PC" will automatically turn on.
5.3.2 Trigger
Event trigger image transfer settings, including:
- Save in PC: The image file is saved in your computer
- Save in Flash Card: The image file is saved in the SD Card
- Mail Image: Send captured event trigger image file by e-mail
- FTP Image: Send captured event trigger image file by FTP
- Shutter Timer: Change shutter time for event trigger image capture, two (2) seconds
is the default setting

5.4 NETWORK SETUP

Network Setup can be used to change the network connection settings of the IP Cam. The
default value for IP assignment is "static". These settings also include:
-
IP Assignment: Static, DHCP, or PPPoE
-
PPPoE settings (PPPoE is the most common type of Broadband Internet connection, where your
ISP assigns a different IP address to your connection each time you log on)
-
HTTP Server port settings
-
DNS settings
* MAC Address:
Displays the Mac
address of the
IP Cam
- Motion Detection (set 2)
14