Operation; Before You Begin; Location Of Controls - FireplaceXtrordinair 36 DV XL Owner's Manual

30

Before You Begin

! Read this entire manual before you use your new fireplace (especially the section "Safety
Precautions" on pages 2 & 3). Failure to follow the instructions may result in property damage, bodily
injury, or even death.
Location of Controls - See explanation below
PILOT ADJ
Gas Control Knob
Blower Knob
On/Off Switch
Pilot Igniter
Gas Control Knob
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The pointer
? If using a remote control or thermostat, the On/Off Switch must be left "ON". Turning the On/Off
Switch "OFF" will keep the fireplace off always.
Travis Industries

Operation

The pilot flame is located
below the back log.
An instruction card for operating the
fireplace is attached to the inside of the
fireplace here. Replace it for easy
reference.
Gas
Control
Valve
Flame Adjust Knob
This knob controls the speed of the internal convection blower that pushes
the heated air into the room.
This control is used to turn the fireplace on and off.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
This knob is used to control gas to the fireplace and for starting the pilot.
There are three positions, ON, OFF, & PILOT. The pointer directly below the
knob indicates the position this knob is in.
to the upper left of the knob points to the position this knob is in.
Open the access door
to view the controls.
OFF
HI
LO
BLOWER
CONTROL
Blower Knob
9 3 5 0 8 1 0 3
PILOT
ON
IGNITER
OFF
Pilot Igniter On/Off Switch
1 5 1 0 0 2