Vent Termination Requirements - FireplaceXtrordinair 36 DV XL Owner's Manual

Installation
Termination Requirements (see the illustration below)
A Minimum 9" clearance from any door or window
B Minimum 12" above any grade, veranda, porch, deck or balcony
C Minimum 12" from outside corner walls
D Minimum 12" from inside corner walls
E Minimum 11" clearance below unventilated soffits or roof surfaces
Minimum 18" clearance below ventilated soffits
Minimum 6" clearance from roof eaves
NOTE: Vinyl surfaces require 24"
F Minimum 18" clearance below a veranda, porch, deck or balcony (must have two open sides)
G Minimum 48" clearance from any adjacent building
H Minimum 84" clearance above any grade when adjacent to public walkways or driveways
NOTE: may not be used over a walkway or driveway shared by an adjacent building
I Minimum 48" clearance from any mechanical air supply inlet, 72" for Canada
J Minimum 36" clearance above and 48Ó below and to the sides of non-mechanical air supply inlet
K Minimum 36" from the area above the meter/regulator (vent outlet)
L Minimum 36" from the meter/regulator (vent outlet)
M Minimum 12Ó above the roof line (for vertical terminations)
* N o t e : In Canada the vent termination must be a minimum 2' (.6 M) tall and 2' (.6 M)
above any portion of the roof within 10' (3 M) of the vent.
N Minimum 24Ó horizontal clearance to any surface (such as an exterior wall) Ð for vertical terminations
G
NOTE: Measure clearances to the nearest edge of the exhaust hood.
¥ Use the vinyl siding standoff (#950) when installing on an exterior with vinyl siding.
¥ Vent termination must not be located where it will become plugged by snow or other material
¥ These clearances meet UMC-1994 and the CNA/CGA-B149 code standards.
Travis Industries
(for qualified installers only)
E
N
M
K
A
F
D
L
9 3 5 0 8 1 0 3
E
I
C
B
Roof
Surface
11Ó Min.
6Ó Min.
E
A
J
H
1 5 1 0 0 2
2 3
Roof
Eaves