FireplaceXtrordinair 36 DV XL Owner's Manual page 45

2 Attach the blower box to the framing or floorboards of the home following the instructions below.
Wall or Ceiling Mounting
Cut a hole between wall
a
framing members for the
blower assembly.
16"*
5-1/4"
* This blower was designed for framing on 16"
centers - construct additional framing if needed.
Floor Mounting
Cut a hole between floor joists
a
for the blower box.
5-1/4"
Slide the blower into the hole
c
cut in step "a". Attach with four
screws.
Travis Industries
Optional Equipment
b
b
14"
9 3 5 0 8 1 0 3
Attach the wall mounting
brackets to the blower box.
Mount the bracket to
these holes for 2 x 4 walls
Mount the bracket to
these holes for 2 x 6 walls
Attach the floor boot to the blower box with the included screws.
Slide the blower, with
c
wires, into the hole cut
in step "a". Attach
with four screws.
The screws
attach to either
of these pairs of
holes. Use the
upper pair for
thick flooring, the
lower pair for
thin flooring.
1 5 1 0 0 2
4 5