Table of Contents
Advertisement
Set Contrast
Sets the contrast of the display. The scanner displays its current contrast level, and by using
the up and down arrow keys the user can change the contrast. The default contrast level is 4,
and the range is from 0 to 7, with 0 being the lightest and 7 being the darkest. To cancel the
change, press the <FN><BK> keys, and to accept the change, press the <ENTER> key.
Set Scanner ID
Sets the MCL-Net address of the scanner. The scanner displays its current ID, and the user
may key in a new value, between 1 and 254.
Set Host Type
Sets the host to be used by the default application. The scanner displays its current host type.
The user can select Other for an RS-232 or Synapse host or MCL-Net for an MCL host. The
default setting is Other. Choosing MCL-Net enables the scanner to communicate with a host
running MCL-Link. Choosing Other selects a standard RS-232 or Synapse host, as defined
by the system installation. (If a Synapse cable is installed, it will be detected and used,
otherwise the RS-232 host will be used.)
Set Scan Options
This menu is used to control the format of data as transmitted by the default application
when the Host Type is set to OTHER. This option does not affect data sent to the MCL-Net
host. Note that unless special programming is implemented in the user's application, this
setting will NOT affect the user's application. (See System Variable 24 in the MCL-Designer
for Phaser Series User's Guide.)
Display Contrast: 4
UP, DN, CL, EN
Figure 3-10. Set Contrast Screen
Enter Scanner ID:
(001 - 254) 001
Figure 3-11. Set Scanner ID Screen
Set Host Type:
Other
Figure 3-12. Set Host Type Screen
Operation
3-11
Advertisement
Table of Contents
