Table of Contents
Advertisement
P 370/470 RF Scanner Product Reference Guide
The first option, Data As Is, indicates that the scanned data will be transmitted to the host
with no modifications. The second option, <PREFIX><DATA>, indicates that a prefix code
will be sent prior to the data. The prefix code is edited using option 5, and should consist of
a one digit Key Category, followed by a three digit Key Code. See Table A-4 on page A-7 for
a list of the Key Categories and Codes.
The third option, <DATA><SUFFIX>, indicates that a suffix code will be sent after the data.
The suffix code is edited using option 6, with the same restrictions as the Prefix Code. The
fourth option, <PFX><DATA><SFX>, indicates that both the prefix code and suffix code will
be sent.
Note that the default value for these options is Data As Is. The default Prefix Code and Suffix
Code are both set to 7013 (the extended keypad ENTER key, which most host variants will
recognize as a carriage return/line feed).
Back To Main
Returns to the main menu, starting at 0. System Setup.
App. Control
The functions under this option allow you to control your application. Specifically, the Load
New System and Set Default App functions.
Enter Host Mode
Puts the scanner into a mode to listen to MCL-Link commands from the host. The scanner
must be in this mode prior to using the Project Send option in MCL-Designer. Users'
applications can also place the scanner in this mode by executing an NS command.
3-12
1. Data As Is
2. PREFIX><DATA>
3. DATA><SUFFIX>
4. PFX><DATA><SFX>
5. Edit Prefix Code
6. Edit Suffix Code
Figure 3-13. Set Host Type Screen
MCLNet Host Mode?
EN=Y BK=N
Figure 3-14. Enter Host Mode Screen
Advertisement
Table of Contents
