Table of Contents
Advertisement
Q u i c k
Troubleshooting
If the scanner does not work after you've followed these operating
instructions:
•
Check the system power.
•
Check that scanning is enabled.
•
Check that the battery is installed correctly.
•
Check for loose cable connections.
•
Be sure the Phaser is programmed to read the type of bar code
you are trying to scan.
•
Check to be sure the symbol is not defaced.
•
Check that the correct power supply is attached to the base/
charger.
•
Check for correct host interface cable or loose cable connec-
tions at the base/charger and host device.
•
Make sure the device is programmed to read the type of bar
code you want to scan.
•
Try scanning similar symbols of the same code type.
•
Make sure the scanner and base/charger have been successful-
ly paired.
•
Be sure you're within the proper scanning and transmission
range (30 to 50 ft., or 9 - 15 meters).
You get frequent communication errors (6 beeps after
decode)
•
Check that you are within transmit range.
•
Check that the scanner is successfully paired with the base/
charger.
You get frequent communication errors (6 beeps after
decode):
Preliminary
•
Check that the base/charger is powered up and that its cable
connections are secure.
R e f e r e n c e
23
Advertisement
Table of Contents
