Symbol P 370 RF Reference Manual page 46

P 370/470 RF Scanner Product Reference Guide
Selecting will enable this feature;
Enabled
option ONLY affects the default application, and does not affect any user applications.
Parameter Control
These functions allow you to control the scanner parameters. Under this option are the Scan
Parameters and Set Default Params functions.
Scan Parameters
Puts the scanner in a mode where parameter bar codes may be scanned. Parameter bar code
scanning is disabled at all other times.
Set Default Params
Restores the default parameters in the scanner. The default parameters overwrite any scanned
parameters. Prior to resetting the default parameters, the user is prompted for confirmation
with a screen similar to the Default Application Confirmation screen.
System Status
The function under this option allows you to perform some system checks. The specific
function under this option is Battery Check.
Battery Check
Checks the battery status. The scanner responds with GOOD, LOW or DEAD! Low battery
status indicates that the scanner will operate for approximately another 25 scans before it
must be recharged. Dead battery status indicates that the scanner will probably not be able
to sustain another scan cycle, and should be recharged immediately.
3-14
Autoload App?
Enabled
Figure 3-17. Autoload Application Screen
Disabled
Scan Parameters
<FUNC><BK> to quit
Figure 3-18. Scan Parameters Screen
Reset Default Parms?
Figure 3-19. Set Default Parameter Screen
with disable this feature. Note that this
EN=Y BK=N