Daikin SkyAir Super Inverter 70 D Series Service Manual page 54

SiE25-110
Notes: 1. Setting is made in all units in a group. To set for individual indoor units or to check the
2. The setting position No. is set to "01" at the factory, except for the following cases in which
3. For further details, see the installation instruction.
4. Since drafts may result, carefully select the installation location.
5. When power returns, units resume the settings made before the power outage.
6. When installing Sky Air simultaneous operation multi-unit, set to "twin".
Caution When "auto restart after power outage reset" is set, be sure to turn off air conditioners, then cut
off the power supply before conducting maintenance, inspection and other work. If the power
supply is cut off with the power switch left ON, air conditioners will automatically start operating
when the power supply is turned on.
7. Do not set any items other than those listed in the above table.
8. Functions that indoor units are not equipped with will not be displayed.
9. When returning to normal mode, "88" may be displayed on the LCD section of the remote
Field Setting
setting, use the mode Nos. (with "2" in upper digit) in parentheses ( ).
"02" is set.
Setting of air flow direction adjustment range 13(23)-4
Automatic restart after power outage. 12(22)-5
Remote control thermostat
Filter sign indication (only for ceiling-mounted duct type) 10(20)-3
Only when the factory setting is changed, it is necessary to make a setting using a remote
controller.
controller due to initialization operation.
Method of Field Set (Reset after Maintenance Inspection/Repair)
45