Making Settings For Each Part - Roland XV-2020 Owner's Manual

Using the XV-2020 as a General MIDI Sound Module

Making Settings for Each Part

Here you can select the GM Patch/Rhythm Set assigned to each Part, and set the volume, pan, and pitch
of each Part.
Parameter
LEVEL
(Part Level)
PAN
(Part Pan)
COARSE TUNE
(Part Coarse Tune)
FINE TUNE
(Part Fine Tune)
PART TYPE
NUMBER
CUTOFF OFFSET
(Part Cutoff Offset)
RESONANCE OFFSET
(Part Resonance Offset)
ATTACK OFFSET
(Part Attack Time Offset)
RELEASE OFFSET
(Part Release Time Offset)
BEND RANGE
(Pitch Bend Range)
MONO/POLY
(Part MONO/POLY)
PORTAMENTO SWITCH
(Part Portamento Switch)
PORTAMENTO TIME
(Part Portamento Time)
98
Value Description
0–127 Adjusts the volume of an individual Part. This setting's main purpose is to adjust the vol-
ume balance between Parts.
RND, L63–63R Adjusts the pan of each Part. L64 is far left, 0 is center, and 63R is far right.
-48–+48 Adjusts the pitch of the Part's sound up or down in semitone steps (+/-4 octaves).
-50–+50 Adjusts the pitch of the Part's sound up or down in 1-cent steps (+/-50 cents).
PATCH, Sets the assignment of a GM Patch (PATCH) or GM Rhythm Set (RHYTHM) to each of
RHYTHM the Parts.
001–256/ Selects the desired GM Patch or Rhythm Set by its number.
001–009
* In GM mode, Patches or Rhythm Sets other than the GM Patches and Rhythm Sets in PR-H
cannot be selected. Furthermore, GM Patches and Rhythm Sets cannot be edited.
-64–+63 Adjusts the cutoff frequency for the GM Patch or Rhythm Set assigned to a Part.
-64–+63 Adjusts the Resonance for the GM Patch or Rhythm Set assigned to a Part.
-64–+63 Adjusts the TVA Envelope Attack Time for the GM Patch or Rhythm Set assigned to a
Part.
-64–+63 Adjusts the TVA Envelope Release Time for the GM Patch or Rhythm Set assigned to a
Part.
0–24 Specifies the amount of pitch change in semitones (2 octaves) that will occur when the
Pitch Bend Lever is moved. The amount of change when the lever is tilted is set to the
same value for both left and right sides.
MONO, POLY Set Mono/Poly to MONO when the GM Patch assigned to the Part is to be played mono-
phonically, or to MONO when the GM Patch is to be played polyphonically.
* For the Part to which the GM Rhythm Set is assigned, this setting will be ignored.
OFF, ON Determines whether the Portamento effect will be applied (ON) or not (OFF). Turn this
parameter ON when you want to apply Portamento and OFF when you don't.
0–127 Adjusts the time over which the pitch will change. Higher settings will cause the pitch
change to the next note to take more time.