Adjusting Effect Settings; Saving Rhythm Sets You Create - Roland XV-2020 Owner's Manual

Parameter
ENV MODE
(Rhythm tone envelope mode)
RCV EXP
(Rhythm tone receive expression
switch)
RCV HOLD-1
(Rhythm tone receive hold 1
switch)
RCV PAN MODE
(Rhythm tone receive pan mode)
RHYTHM MFX (Rhythm Multi-Effects)
Parameter
TYPE
(Multi-Effects Type)
SEND LEVEL DRY
(Multi-Effects Dry Send Level)
SEND LEVEL CHO
(Multi-Effects Chorus Send Level)
SEND LEVEL REV
(Multi-Effects Reverb Send Level)
CONTROL SOURCE 1–4
(Multi-Effects Control Source 1–4)
DESTINATION 1–4
(Multi-Effects Control Destination 1–4)
SENS 1–4
(Multi-Effects Control Sensitivity 1–4)
RHYTHM CHORUS
Parameter
TYPE
(Chorus Type)
LEVEL
(Chorus Level)
OUTPUT SELECT
(Chorus Output Select)
RHYTHM REVERB
Parameter
TYPE
(Reverb Type)
LEVEL
(Reverb Level)

Adjusting Effect Settings

Refer to Patch/Rhythm Set Mode Settings (p. 77).

Saving Rhythm Sets You Create

Refer to Saving a Sound You Create (p. 92).
Value Description
NO-SUS, SUSTAIN When a loop-type waveform is selected, it will normally continue to sound as
long as a key is pressed. If you want a note to decay naturally even when the
key remains pressed, set this to "NO-SUSTAIN."
* If a one-shot type Wave is selected, it will not sustain even if this parameter is set
to "SUSTAIN."
OFF, ON If you want the Rhythm Tone to respond to Expression messages, turn this pa-
rameter on. If not, turn it off.
OFF, ON If you want the Tone to respond to Hold 1 messages, turn this parameter on.
If not, turn it off.
CONTINUOUS, CONTINUOUS: Pan messages will be responded to immediately, instantly
KEY-ON changing the stereo position of the Rhythm Tone. KEY-ON: The stereo loca-
tion of the Rhythm Tone will be changed only when the next note is played. If
a Pan message is received while a note is sounding, its stereo location will not
change.
Description
Refer to p. 80.
Description
Refer to p. 80.
Description
Refer to p. 80.
Creating a Rhythm Set
69