Establishing Settings For An Entire Xv-2020 (System Common) - Roland XV-2020 Owner's Manual

Establishing Settings for an Entire
XV-2020 (SYSTEM COMMON)
SYSTEM COMMON
Parameter
MASTER LEVEL
MASTER TUNE
PATCH REMAIN
(Patch Remain Switch)
MASTER KEY SHIFT
CLOCK SOURCE
(System Clock Source)
TEMPO
(System Tempo)
PERFORM CTRL CH
(Performance Control Channel)
PATCH RCV CH
(Patch/Rhythm Set Receive Channel)
RCV PC
(Receive Program Change Switch)
RCV BS
(Receive Bank Select Switch)
SYSTEM CTRL SRC 1–4
(System Control Source1–4)
94
Value Description
0–127 Adjusts the volume of the entire XV-2020.
415.3–466.2 Hz Adjusts the overall tuning of the XV-2020. The setting is expressed as the fre-
quency played by the A4 key.
OFF, ON This specifies whether you want the notes that are sounding to remain (ON)
or turn off (OFF) when you select a new Patch or Rhythm Set in Patch mode.
In addition, when "ON" is selected, the Volume and Pan data, and the Key
Mode and other settings received via MIDI (CC 5, 7, 10, 65, 68, 71–74, RPN 0,
1, 2, MONO ON, POLY ON) are passed on.
-24–+24 Shifts the overall pitch of the XV-2020 in semitone steps.
INT, MIDI, USB Specifies the tempo clock of the system.
INT: The internal clock
MIDI: An external clock received via MIDI IN connector
USB: An external clock received via USB connector
20–250 Sets the system tempo. When Clock Source is set to "MIDI" or "USB," the
tempo will synchronize to the clock messages received from an external de-
vice, so the tempo value will be ignored.
1–16, OFF When changing Performances by MIDI messages from the external device,
set the transmit channel of the external device and this channel to the same
channel.
* When you perform a Factory Reset operation, Control Channel is reset to "16."
1–16 Set this channel to use an external MIDI device (such as a MIDI keyboard) for
playing Patches and Rhythm Sets, or to have Patches or Rhythm Sets
changed as the result of MIDI messages.
OFF, ON Specifies whether Program Change messages will be received (ON), or not
(OFF).
OFF, ON Specifies whether Bank Select messages will be received (ON), or not (OFF).
OFF, CC01–31, These settings allow you to choose four MIDI controllers for global use when
33–95, BEND, controlling the parameters of any Patch or Performance. The settings in each
AFTER Patch or Performance will determine whether the two controllers you choose
here will actually be used. In each Patch or Performance, you will also need
to specify the parameters to be controlled.
OFF: No controller is used.
CC01–95: Controller numbers 1–95 (except for 32)
BEND: Pitch Bend
AFTER: Aftertouch