List Of Parameters That Can Be Affected Using The Xv-2020 - Roland XV-2020 Owner's Manual

List of Parameters That Can Be
Affected Using the XV-2020
Switching modes
Mode
Patch Play Mode
Performance Part Play Mode
Performance Play Mode
Rhythm Play Mode
GM Play Mode
Patch Edit Mode
Performance Edit Mode
Rhythm Edit Mode
GM Edit Mode
SYSTEM parameter
Parameter
Master Tune
Performance Control Channel
MIDI-USB thru
USB Descriptor
PATCH parameter
Parameter
LEVEL
PAN
COARSE TUNE
FINE TUNE
OUTPUT ASSIGN
CUTOFF OFFSET
RESONANCE OFFSET
ATTACK TIME OFFSET
RELEASE TIME OFFSET
OCTAVE SHIFT
ANALOG FEEL
PERFORMANCE parameter
Parameter
PART LEVEL
PART PAN
PART COARSE TUNE
PART FINE TUNE
PART OUTPUT ASSIGN
PART VOICE RESERVE
PART REVERB SEND LEVEL
PART CHORUS SEND LEVEL
PART DRY SEND LEVEL
PART TYPE (PATCH/RHYTHM)
PERFORMANCE MFX SOURCE
Page Procedure
p. 35 Press [VALUE] to make the PATCH indicator lights up.
p. 38 Press [VALUE] to make the PATCH (RHYTHM) and PERFORM indicators light.
p. 38 Press [VALUE] to make the PERFORM indicator lights up.
p. 35 Press [VALUE] to make the RHYTHM indicator lights up.
p. 96 Press [VALUE] to make the GM indicator lights up.
p. 44 In Patch Play Mode, while holding down [VOLUME], press [VALUE].
p. 70 In Performance Play Mode and Performance Part Play Mode,
while holding down [VOLUME], press [VALUE].
p. 62 In Rhythm Play Mode, while holding down [VOLUME], press [VALUE].
p. 96 In GM Play Mode, while holding down [VOLUME], press [VALUE].
Page Procedure
p. 94 While holding down [VOLUME], press [VALUE].
Turn [CATEGORY/BANK] to choose the parameter you want to set. ->
Turn [VALUE] to select the desired setting. ->
Pressing [VALUE] to set values (Write). ->
While holding down [VOLUME], press [VALUE].
* Changes made to the MIDI-USB Thru and USB Descriptor settings are not reflected until
the power is turned off, then on again.
p. 94
p. 95
p. 95
Page Procedure
p. 46 Press [VALUE] to make the PATCH indicator lights up. ->
p. 46
While holding down [VOLUME], press [VALUE]. ->
p. 46
Turn [CATEGORY/BANK] to choose the parameter you want to set. ->
p. 46
Turn [VALUE] to select the desired setting. ->
p. 46
While holding down [VOLUME], press [VALUE].
p. 47
p. 47
p. 47
p. 47
p. 46
p. 47
Page Procedure
p. 72 Press [VALUE] to make the PERFORM indicator lights up. ->
p. 72
While holding down [VOLUME], press [VALUE]. ->
p. 72
Turn [CATEGORY/BANK] to choose the parameter you want to set. ->
p. 72
Turn [VALUE] to select the desired setting. ->
p. 73
While holding down [VOLUME], press [VALUE].
p. 73
p. 79
p. 73
p. 73
p. 72
p. 80
117