Effect Settings (Effect); Switching The Effect Type - Roland GR-55 Owner's Manual

Effect Settings (EFFECT)

The GR-55 contains seven effects processors (AMP, MFX, MOD, CHORUS, DELAY, REVERB, EQ), which are organized as shown in the illustration below.
(The illustration is for Structure 1.)
PCM TONE 1
PCM TONE 2
MODELING TONE
NORMAL PICKUP
By internally connecting effects to the PCM tones and the modeling tone that make up the patch, you can create a broad range of sounds.

Switching the Effect Type

Effects are already applied to the patches built into the GR-55. By
editing these settings, you can change the sound to your taste.
1. Select the patch whose effect settings you want to edit (p . 16) .
2. Press the [EDIT] button to access the EDIT screen .
3. Use the PAGE [ ] [ ] buttons to select the EFFECT tab .
The screen shows the effects that are applied to the currently selected
patch.
4. Turn an effect on/off .
Use the cursor buttons to select an effect, and use the dial to
turn that effect on /off
38
AMP
Preamp
.
MFX
Multi-effect
MOD
Guitar effects
5. Switch the effect type .
Use the cursor buttons to select the effect whose type you
want to change, and use the dial to switch the effect type.
The effect types are listed as shown in the illustration.
6. Press the [ENTER] button .
7. When you've finished editing, press the [EXIT] button .
8. If you want to keep the changes you made, save the patch
(p . 60) .
EQ
Equalizer
CHORUS DELAY REVERB