Motor to Stand Assembly
- Motor Mounting
1. Have an assistant hold the Motor in place while it is
attached to the Motor Plate (7). Turn it so that the
mounting slots on the Motor face the Motor Plate.
2. There are two sets of slots on the Motor Plate.
Line the Motor Pulley up with the Saw
Pulley above it. See Figure 11, right.
3. Insert a Bolt (53) and Washer (58) through each slot
from one side, and secure the Motor to the Motor
Plate using the Bolt, Washer, Lock Washer (57),
and Nut (60). See Figure 12, right.
NOTE: Leave the Nuts snug, but do
not tighten them completely yet.
4. Remove the nylon cable tie that secured
the Power Cord (20) during shipment.
Item 60564
For technical questions, please call 1-800-444-3353.
Figure 11
Figure 12
Power
Cord
(20)
Motor Plate (7)
Saw
Pulley
(103A)
Motor
Pulley
(103)
Page 9