Maintenance - Central Machinery 60564 Owner's Manual & Safety Instructions

Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool to its "OFF" position and unplug the tool from its electrical
outlet before performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts,
• damaged electrical wiring, and
• any other condition that may
affect its safe operation.
2. DO NOT INTRODUcE WATER INTO
THE ELEcTRIc MOTOR THROUGH
THE MOTOR VENTS.
Page 20 For technical questions, please call 1-800-444-3353.
3. Do not use solvents to wipe off the
Bandsaw, as damage may result.
4. With a brush or soft cloth, remove all the sawdust
from within the Lower Wheel Guard of the Bandsaw.
5. If necessary, wipe with a damp cloth. A
mild detergent can also be used.
6. Once clean, lubricate all moving parts with a light oil.
7. WARNING! If the supply cord of this
tool is damaged, it must be replaced only
by a qualified service technician.
8. Store the Bandsaw covered with a cloth cover.
Item 60564