Central Machinery 60564 Owner's Manual & Safety Instructions page 11

Table
Assembly
1. Set the Table Bracket (45A) onto the saw body
as shown in Figure 15, right. Note that the Table
Stop bolt hole is on the side with the Pulleys.
The saw body has alignment pins pre-installed
to align the Table Bracket properly.
2. Secure the Table Bracket to the Saw Body using
Bolts (91A) and Lock Washers (92A).
Tighten securely in place.
3. Thread the Nut (48A) onto the Table Stop Bolt (47A).
Install the Table Stop Bolt into the
hole noted in Figure 15.
4. Attach the Bracket Post (55A) to the saw
body next to the Table Bracket. Secure
in place with two Hex Bolts and Flat
Washers, as shown in Figure 16, right.
NOTE: The hardware for this step is packaged
separately from the hardware bag.
5. Locate the Table Bracket. Note that there are two
Bolts (40-1A) extending out from the bottom of the
Trunnions (42A). Insert those two Bolts through
the holes in the Table Bracket and secure the Bolts
in place using Knobs (46A). See Figure 17, right.
Item 60564
47A
Trunnion
(42A)
Bracket
Bolt (40-1A)
Knob (46A)
For technical questions, please call 1-800-444-3353.
91A
Figure 15
Table Bracket (45A)
Figure 16
Bracket
Post (55A)
Figure 17
Table
(45A)
48A
92A
Table Stop
Bolt Hole
Page 11