Central Machinery 60564 Owner's Manual & Safety Instructions page 12

pulley cover Assembly
and Belt Installation
1. Set the Pulley Box (11) over the Top Pulley (63A)
and Saw Pulley (103A) with the door opening
to the outside. See Figure 18, right.
2. Insert a Pan Head Bolt (62) through a Washer (56)
and into each of the four holes at the bottom of
the Pulley Box. Secure the Bolts from underneath
using one Washer and Nut (61) each.
3. Secure the Pulley Cover Knob (63) to the
door using Bolt (54) and Washer (59) from
the other side. Do not overtighten.
4. Close the Pulley Box door temporarily to make
sure it closes completely and securely.
Belt Installation
5. Slide the Motor up towards the top of its
rail to allow easy belt installation.
6. Using the chart above, choose which speed
you would like the blade to operate at initially.
Slide the Belt (102A) onto the desired
Motor Pulley (12) position. Then slide the
Belt up over the Saw Pulley (103A) in the
same position. See Figure 19, right.
7. To set Belt tension, have an assistant pull down on
the Motor and hold it in place to put tension on the
Belt. Then test the belt's tension by gently pushing
in on it in between pulleys. If it only deflects about
1/2" to 3/4" from straight, then the belt is properly
tensioned at that motor position. While the assistant
holds the motor at that position, secure the motor in
place with the previously loosened Bolts and Nuts.
8. After tightening, verify that both
pulleys are still aligned.
Page 12 For technical questions, please call 1-800-444-3353.
59
54
Figure 18
Pulley Box (11)
Top Pully
(63A)
Saw Pulley
(103A)
Figure 19
4
Saw Pulley
(103A)
1D
3D
4
pulley Speed Settings
position 1
Output
568 1080
FpM
Note: The unnumbered innermost position
on the Saw Pulley should ONLY be
used to drive the Top Pulley (63A), and
should not be used to change speeds.
56
63
62
61
Pulley
Box Door
1
2
3
Motor Pulley
(12)
1
2
3
2 3 4
1582 2529
Item 60564